With the brew stand nearing completion one of the things I wanted to do was run my large volume equipment through a brew day. This is not my complete setup, I used only one of the large vessels instead of both and I don’t have my pumps hooked up yet.
My process is pretty common with this setup:
- heat large volume of water in HLT but what will become the BK
- mash in with portion of hot water
- add more water back to HLT and heat up for sparge
- transfer all sparge water to coolers and empty the vessel
- sparge from coolers into MLT and lauter into BK
This gives me two vessels to work with and the need for only one burner. I actually use two burners in case of the need to heat the MLT. The second time I brewed on this set up I didn’t need to heat the MLT but the first time I did.
Here are a few pics of the process…
Mashed into a 50L keggle which according to my calculations would be able to hold 40lbs of grain. It did but it was completely MAXED out. No more room for anything! That was, in fact, my intent with this particular brew: max out every vessel to find out what my volume limits were. I found out. 😉
MLT maxed out
Tried a new technique for me this time: fly sparging. It’s just setting the flow of sparge water to match the flow of lautering. Not difficult it’s just that I had never been set up for that before. Discovered it’s the best thing ever! It’s just too easy and there’s really no babysitting of the MLT or much scooping of water involved.
My fly sparge setup.
I did heat my MLT half way through the rest to bring the temp back up. With the MLT maxed out there was really no room for much stirring so I really didn’t have an accurate sense of the temperature. After emptying the MLT I did see that there was a bit of scorching evident but I’m sure I’ll still end up with beer.
Lautering and boiling were just fine and got to about 80L or so pre-boil. Another new addition to my set up is the plate chiller seen in this photo on the work bench. (The pump and burner are courtesy of Scott.) Sanitizing the plate chiller prior to chilling was dead easy. I just hooked everything up in the last ten minutes of the boil and ran the boiling wort through the system. This dropped the temp a bit and halted the boil for a minute or so but I just kept running the system and the boil came back. Super easy!
Sanitizing the chiller
The chilling and cooling in itself was super easy. Once the boil was done I whirlpooled and rested (manually, just by stirring the BK). My chiller was already set up from the sanitizing stage so all I had to do was get my carboys in place and fire it up. With this set up and the water turned on about a half turn on the faucet I was able to cool and transfer the full volume of about 80L in just 10 minutes! You can also see it’s reasonably aerated, not something I’ve worried about a whole lot but it’s certainly not a gentle transfer.
There are a few things that will be changing with this setup and moving to the brew stand: My pumps will be wired in, burners will be in place, less moving of vessels, more space for me to move around. All of this… Soon.